Home »
Cement / Concrete Testing Instruments
Cement / Concrete Testing Instruments
IIC - 237
ROLL CRUSHERS
 |
|
|
A Roll Crusher is basically intended for crushing
various hard materials like ores and minerals of large size into a smaller
size. As the name implies, two hardened alloy steel rollers with smooth
surfaces, rotate to crush the material fed.Roll Crusher (small).
Technical Parameters:
Size :-4" x 8" This comprises of two hardened alloy steel rollers
with 100mm, faces and 250mm. diameters. The rollers are fitted to a steel
shaft and are mounted on heavy duty gunmetal bearings. The outside bearings
are provided with heavy duty compression springs. Which help in increasing
the space between the rolls, when a piece of material cannot be crushed.
Square threaded bolts are provided to adjust the gap between the rolls. The
drive is by a heavy motor, through 'V belts, to a set of gears and further
to the rollers. A hopper is provided for feeding the material. The whole
arrangement is mounted on a fabricated steel material. Supplied complete
with a 3.0 H.P motor and starter.Wired fro 440V. 3 Ph. 50 Hz. Feed
Size:10mm(maximum) Product Size :2.00mm and below.
IIC - 238
STRAIGHT EDGE
Available In Size : 2"X18"(5.1
X45.7CM), 1"X12"(2.5X30.4CM)
IIC - 239
GAUGING TROWEL
As per BS12, IS 4031
Technical Parameters:
Weight approximately 210 gms. Best quality with hard wood handle blade
length 200mm
IIC - 241
VEE BEE CONSISTOMETER
AS & BSEN 12350
The instrument is used for workability as well as consistency of fresh
concrete. A slump Cone and a graduated rod supplied with the instrument
helps the operator to find out slump values and vibration table with
container and acrylic disc is used to find out workability of concrete
expressed in Vee Bee degrees, which is defined as the time in seconds to
complete required vibrating at which the fresh.
IIC - 242
TENSILE STRENGTH TESTER
(ELECTRICALLY OPERATED)
As Per IS : 269 1958, BS 12
Technical Parameters
The instrument employs a friction free, accurate, double lever system, the
load being applied by means of sliding weight on the top lever. The capacity
of the units is 900 kgs.After fixing the briquette in the jaws, the machine
is switched on. The sliding weight slides over the calibrated lever thus
applying tension to the specimen. A micro switch fitted instantly stop the
machine on failure of the briquette and on failure the tensile load is
accurately 0.5kg. By means of a marker provided on the sliding, weight to
its zero position. Suitable for operation on 230 V,50 cycles, Single Phase,
A.C. supply. Complete with one brass briquette mould and one base plate.
